paxconsumer.blogg.se

Revtor profile for ncs expert windows xp
Revtor profile for ncs expert windows xp










Do you want to empty the file?Ĭlick on Zuruck (F6) and close the interfaceįree Download TOYOTA Techstream V18.00.008 It’s recommended to empty this file after coding. Then close NcsDummy and will pop up message: trace manipulation file “FSW_PSW.MAM” is not empty. Then click on SG auslesen (F4), and get the new infoīrowse for FSW/PSW or Nettodate trace 1 (it’s PSW_PSW.TRC) Go to the menu bar, select File-> Load file (the port is close to the left front door, near the the steering wheel) Using K+DCAN cable to change E60 navigation language display:įirst: check the battery and ignition status in INPA Only Italian, Dutch, English available in iDrive menu if using this method

revtor profile for ncs expert windows xp

To change the navigation language for free: To change bmw navigation display language

revtor profile for ncs expert windows xp

  • Car Detailing and Show & Shine Prep sponsored by Autogeek.This is step-by-step guide on how to use BMW INPA K+DCAN cable to change E60 navigation language, running with bmw software inpa, ncs expert and ncs dummy.
  • Car Audio & Electronics sponsored by Bavsound.
  • Tire & Wheel Forum sponsored by The Tire Rack.
  • Suspension Tech and Handling sponsored by.
  • Professional Motorsports sponsored by Bimmerworld.
  • Track, Auto-X & Drag Racing sponsored by.
  • General BMW and Automotive Discussion sponsored by Intercity Lines.
  • Quick Navigation Diagnostic Software Go Top Install ISTA D (the Rheingold version is easiest), configured to use your DCAN interface and try diagnosing your car.Īs I said earlier, not all K+DCAN interfaces work and the ones with white circuit boards have a particularly bad reputation. Try the interface on another car (ideally a 2009 or 2010 model) and, if successfulģ.

    revtor profile for ncs expert windows xp

    Set your interface and OBD.ini com ports to COM3 and see if you can establish communication (you will probably need to be using EDIABAS v7.*.* for this car, which rules out using DIS)Ģ. The other issue is that both DIS v57 and INPA will probably be too old to contain the file versions required for your car unless they have been manually updated. You can Google and download MPROG v3.5 which will allow you to read the EEPROM data from your interface. As 328 Power said, port must be set to COM3 in OBD.ini this is the setting I use with my One Stop Electronics K+DCAN interface and DIS v57 when working on my 2008 E70 but does not address whether the programming of the EEPROM in your interface is correct or whether the interface works.












    Revtor profile for ncs expert windows xp